Wall Mount - Cisco 8011-2X2XP4L Hardware Installation Manual

Wall Mount

Figure 20: Installing ETSI Rack-Mount Brackets in the Middle
2. Install the router onto the 2-post rack as follows:
a. Lift and position the router into position between the two rack posts.
b. Move the router until the rack-mount brackets come in contact with the two rack posts.
c. Hold the chassis at level and have another while the second person inserts two screws 12-24 in each
d. Tighten the 12-24 screws to 30 in-lb (3.39 N.m).
Wall Mount
The device is shipped with wall mounting brackets that are to be secured on the sides of the device.
Install the wall mounting brackets and cable guides on to the chassis before you mount the chassis on the wall.
Install Wall Brackets
1. Remove the wall mounting brackets from the accessory kit and position them beside the device.
Note
Hardware Installation Guide for Cisco 8011-2X2XP4L PLE Service Endpoint Router
36
1
2
3
of the two rack-mount brackets (using a total of four screws) and into the cage nuts or threaded holes
in the vertical rack-mounting rails.
You can install the brackets as shown in the figure.
Mount Bracket
Cable Management Bracket
Screw
Install the Device