Install The Ac Power Supply Module - Cisco 8011-2X2XP4L Hardware Installation Manual

Install the AC Power Supply Module

Step 3
Remove the power cord from the power connection on the power supply. Do not touch the metal prongs embedded in
the power supply.
Step 4 Grasp the power supply handle. Press the power supply lock towards the left and simultaneously pull the power supply
out from the chassis while supporting it with the other hand.
Install the AC Power Supply Module
Follow these steps to install the AC power supply module:
Step 1 Ensure that the system (earth) ground connection is made.
Step 2 If necessary, remove the blank power supply filler plate from the chassis power supply bay opening by loosening the
captive installation screws.
Step 3
Grasp the power supply handle with one hand. Place your other hand underneath the power supply. Slide the power
supply into the power supply bay. Make sure that the power supply is fully seated in the bay. (See the following figure.)
Figure 32: Install AC Power Supply Module
1 Power supply handle
Step 4 Slide the AC power supply cord inside the tie of the tie-and-holder and tighten the tie around the power supply cord.
Step 5
Plug the power supply cord into the AC power supply.
Hardware Installation Guide for Cisco 8011-2X2XP4L PLE Service Endpoint Router
60
2 Power supply lock
Replace Power Supply