Bass Removal - Bowers & Wilkins 704 S2 Series Service – Technical Manual

Hide thumbs Also See for 704 S2 Series:

Table of Contents

7. Bass Removal

Start by putting your fingers against the

Rubber inner and your thumb on the

edge of the Cabinet and gently ease the

Aluminium Trim (1) outwards.

Pull evenly around the Aluminium Trim

so as not to bend the Plastic Pegs. Con-

tinue this until the Trim comes away

from the Cabinet.

Note: When reassembling, look to

align the 4 x Plastic Pegs on the Alu-

minium Trim with the Plastic Sockets

on the cabinet.

Place the 704 Series 2 on its back and use Tool 1.3 – Allen Key 3.0mm to remove the 4 x Hex

Bolts (2-5).

This will allow you to safely remove the Bass Unit without damaging the Cabinet.

The contents of this document and associated files contain confidential information that is propriety to B&W

Group Ltd., and are intended solely for the purpose of servicing the product. The information is intended for use

by service technicians familiar with electronic products. No part of the contents should be supplied or published

elsewhere.

Page 20

Table of Contents