Bowers & Wilkins 704 S2 Series Service – Technical Manual page 13

Hide thumbs Also See for 704 S2 Series:

Table of Contents

Carefully ease the Tweeter forward from the cabinet and remove the Black (-) (1) and Red

(+) (2) Leads. Ensure that the Foam Gasket (3) remains in position for reassembly. (Take

note of the red paint on the right (+) Tweeter connection, this is to show the Red (+) cable

position)

Note: If the Tweeter is stuck in position and cannot be eased forward it may be necessary

to remove the Mid/Base Speaker. This will allow access to the rear of the Tweeter Assem-

bly so that you can gently push it forward until free.

With the Tweeter Assembly removed, access

to the rear of the Tweeter can be gained. Start

by removing the 4 x Screws (4-7) around the

Plastic Retainer. The Plastic Retainer can then

be removed and placed to one side.

Note: Take care removing the Plastic Retainer

so as not to damage the Rubber Gasket.

The contents of this document and associated files contain confidential information that is propriety to B&W

Group Ltd., and are intended solely for the purpose of servicing the product. The information is intended for use

by service technicians familiar with electronic products. No part of the contents should be supplied or published

elsewhere.

Page 13

Table of Contents