Bowers & Wilkins 704 S2 Series Service – Technical Manual page 19

To carry out the adjustments you should attach Tool 1.3 – HH15121 MF Removal Tool to the
nut (1) and then slide Tool 1.1 – HH15148 Screwdriver 4mm x 100mm into the end of the
MF Removal Tool. Position the Screwdriver so that it finds the slot in the top of the Drawbar
(2).
To Move the Mid Outwards
To bring the Mid Unit towards you will need to also loosen the nut which holds the Mid
Unit in position on the Drawbar. To do this please follow the below steps:
•
Firstly, loosen the nut by turning the MF Removal Tool (1) anti-clockwise
•
Secondly, simultaneously turn both tools (1 & 2) anti-clockwise until the Mid Unit sits
in the desired position.
•
Finish by turning the MF Removal Tool (1) clockwise to tighten the nut so that the
Mid Unit is secure on the Drawbar. Do this with the Screwdriver in place to stop the
Mid rotating. Ensure you do not over tighten.
To Move the Mid Inwards
To move the Mid Unit inwards please follow the below steps:
•
Turn the Screwdriver (2) clockwise until the Mid Unit sits in the desired position.
•
Turn the MF Removal Tool (1) clockwise to tighten the nut so that the Mid Unit is
secure on the Drawbar. Do this with the Screwdriver in place to stop the Mid ro-
tating. Ensure you do not over tighten.
The contents of this document and associated files contain confidential information that is propriety to B&W
Group Ltd., and are intended solely for the purpose of servicing the product. The information is intended for use
by service technicians familiar with electronic products. No part of the contents should be supplied or published
elsewhere.
Page 19
1
2
© B&W Group Ltd 2017