Canopy Latch - BVM KingCat V2 COMPOSITE Assembly And Operating Manual

CANOPY LATCH

Carefully Dremel the marked slot, test fit the Hatch
Latch to insure a good fit to the slot. Once satisfied
scuff the side of the Hatch Latch that will come in
contact with the fuse. Also scuff the fuse with some
sandpaper.
Glue the Hatch Latch using QTpoxy.
After cure, put tape on both sides of a straight blade
to protect the paint.
Use the blade to trim the plastic back to the fuse.
Place masking tape at the approximate location
where the Hatch Latch pin will strike the canopy
frame.
Use a sharpie or something similar, mark on the tip
the hatch pin, place the canopy in position, and let
the hatch pin strike the tape a few time to mark the
spot.
Use a 3mm or #31 drill to make a hole at the
marked spot.
Test fit the canopy and Hatch Latch to insure the
are working correctly.
Taper the forward end of the carbon fiber receptacle and glue into place lining up the
holes.
BVM ® 2023
KingCat-V2
Assembly & Operation Manual
13 12/2023