Spirit XT385 Owner's Manual page 32

3. While kneeling beside your treadmill deck, use one hand to hold the treadmill belt up and away from the
treadmill base just enough so you can use your other hand to reach the lubrication underneath.
Starting about 1 foot from the motor cover, begin applying ½ of your lubricant bottle in a long "S" pattern
4.
about 4-6" from one edge.
5. Repeat steps 3 and 4 on the opposite side using the remaining ½ of the lubricant bottle.
1. Plug the unit power cord back in and turn the power switch back on.
2. Walk on the belt at a moderate speed for 5 minutes to evenly distribute the lubricant along the treadmill belt
and deck.
3. Your treadmill belt is now lubricated. Normal use can resume.
Regularly check belt lubrication by completing the following steps:
1. Ensure that your treadmill is off and that the power cord is unplugged to minimize the risk of injury.
2. Reach between the running belt and the top of the treadmill base to verify that lubrication is present.
BELT AND DECK CLEANING & CALIBRATION PROCEDURE
Belt & Deck Cleaning
To clean your treadmill belt:
1. Ensure that your treadmill is off and that the power cord is unplugged to minimize the risk of injury.
2. Grab one edge of the treadmill belt and lift slightly to expose the area between the top of the treadmill base
and the running belt.
3. Do a visual check for any dirt or debris accumulation.
4. Should dirt and debris be present, slide a towel or cleaning cloth between the treadmill belt and the top of
the treadmill base until you can grasp one end on each side. (The cleaning cloth should be longer than the
running belt is wide to achieve this.)
5. Using both hands, drag the cleaning cloth up and down the length of the treadmill base 1-2 times.
6. For excessive dirt accumulation, rotate the belt halfway, and repeat step 5. Continue until your cleaning
cloth is no longer picking up any dirt.
7. Remove the cleaning cloth from the treadmill before plugging it back in.
Calibration Procedure
1. Remove the Safety Key.
2. Press and hold Start and Speed + buttons and at the same time replace the Safety Key. Continue to hold
Start and Speed keys until the window displays "Factory settings", then press the Enter key.
3. You will now be able to set the display to show Metric or English settings (Miles vs. Kilometers). To do this,
press the incline +/ - key to show which you want, then press Enter (The maximum speed value is
displayed in the speed window, and the maximum elevation value is displayed in the incline window.)
Grade return – On (This allows the incline to return to zero when the Stop button is pressed. For sale in
4.
Europe, EU standards require this to be off)
5. Press the Start button to begin calibration. The process is automatic; the speed will start up without warning,
so do not stand on the belt.
Customer Service 1-888-707-1880
Email: customerservice@dyaco.ca
31
Dyaco Canada Inc. 2023