Spirit XT385 Owner's Manual page 8

Location Requirement
After assembling your treadmill, you'll need to make sure you've installed it in a safe area.

We recommend that you leave an area of at least 20in on the front and sides of your
treadmill. The front of the unit is where the motor is located.

We recommend that you leave an area of at least 6ft behind the treadmill.

Install your treadmill in an area where children and pets cannot access it.

Always keep the area around your treadmill clear of furniture, exercise equipment and
other debris.

Do not install your treadmill on deeply padded, plush, or shag carpet.
PRE-ASSEMBLY
!!ATTENTION: IMPORTANT UNPACKING INSTRUCTIONS.
PLEASE READ BEFORE UNPACKING YOUR FOLDING TREADMILL!!
WARNING: There is a Velcro strap installed
around the treadmill base that prevents the
unit from unfolding accidentally during
shipping. If this strap is not removed
properly the treadmill could spring open
unexpectedly and cause injury if someone is
standing near the unit when the strap is
removed
To ensure your personal safety during
removal of the shipping strap please make
sure the treadmill is positioned flat on the ground, in the orientation it would be in if you were
using the treadmill. Do not turn the treadmill up on its side while removing the shipping strap.
This could cause the unit's folding mechanism to spring open. If the end of the Velcro strap (that
you need to grab to remove it) happens to be under the treadmill deck, reach under the deck to
grab it, but do not tilt the treadmill up to gain access to the strap end.
1. Cut the straps, then lift the box over the unit and unpack.
Customer Service 1-888-707-1880
Email: customerservice@dyaco.ca
7 Dyaco Canada Inc. 2023