Copy Id Via Ecu Info - Xtool TP Series User Manual

If so, click button to start programming; if not. Click "Back" button and detect again.

COPY ID VIA ECU INFO

This allows you to get the ID from TPMS info and program the ID in XTOOL sensor.
Before doing that, make sure you have already done diagnostics to the TPMS.
After diagnostics, go to "Copy ID via ECU info,", press "OK" to view sensor information.
Select the tire you want to replace the sensor, then go to programming.
Put the sensor you need to program close to the top of the tool. The tool will automatically scan the sensor and show it on
the screen.
The screen will show the S/N of the sensor when detected; check iif the S/N is correct.
If so, click button to start programming; if not. Click "Back" button and detect again.
10