Manually Input Id; Copy Id Via Activation - Xtool TP Series User Manual

MANUALLY INPUT ID

This allows you to input the sensor ID manually and program it into one sensor. If the ID you wrote into the sensor doesn't
match the ID that are saved inside the system, you need to do a relearn after installation.
To program the sensor, select "manually input ID" on the tool, then input the ID, press OK key to confirm.
Put the sensor you need to program close to the top of the tool. The tool will automatically scan the sensor and show it on
the screen.
The screen will show the S/N of the sensor when detected; check iif the S/N is correct.
If so, click button to start programming; if not. Click "Back" button and detect again.
⚠ Note: The ID could be decimal (0-9) or hexadecimal (0-9,A-F). Make sure you are using the correct ID
format; it could be changed in settings.

COPY ID VIA ACTIVATION

This allows you to get the ID from activation and program the ID in XTOOL sensor.
Before doing that, make sure you have already checked the sensors on the vehicle.
After checking the sensors on the tire, go to "Copy ID via activation,", press "OK" to view activated sensor information.
Select the tire you want to replace the sensor, then go to programming.
Put the sensor you need to program close to the top of the tool. The tool will automatically scan the sensor and show it on
the screen.
The screen will show the S/N of the sensor when detected; check iif the S/N is correct.
9