Omron sysmac EtherNet/IP NJ Series Connection Manual page 38

14
As shown in the figure on the
right, the font color that is used
to display the synchronized data
changes to the same color as
the one used to specify
"Synchronized". Check that a
message is displayed stating
"The Synchronization process
successfully finished".
Confirm that there is no
problem, and click Close.
*When the project data created
in Sysmac Studio matches the
Controller data, a message is
displayed stating "The
Synchronization process
successfully finished".
*If the synchronization fails,
check the wiring and repeat
from step 1.
15
Check that the ERR/ALM
indicator in the Controller Status
Pane changes to a green color
and that PROGRAM mode is
displayed.
Precautions for Correct Use
If you change the connection settings (i.e. tag data link table) after synchronization, you
cannot transfer the changed connection settings by synchronizing the data again.
To transfer the connection
settings changed after
synchronization, display the
Built-in EtherNet/IP Port
Settings - Port 2 Connection
Settings Tab Page and then
click Transfer to Controller.
7．EtherNet/IP Connection Procedure
35