Orientalmotor alphaSTEP ARL Series Setting Manual page 49

Hide thumbs

Table Of Contents

Table of Contents

Monitor item

I/O

RIO

RX8 (RX13)

RX9 (RX14)

DIO

In1

S-IN

ALL

(OUT1)

(OUT2)

(OUTA)

Enc

(RW)

(RWw1)

(RWw2)

(RWr1)

(RWr2)

(RWr3)

(RWr4)

(RWr5)

(RWr6)

(RWr7)

(RWr8)

Display

(TW-END)

Press the F4 to change the status of TW-END to

F4: ON/OFF

ON or OFF.

CRD

Press the F4 to change the status of CRD to ON

F4: ON/OFF

or OFF.

ALL

It is possible to switch each signal between ON and

OFF state by pressing the specified numerical key.

•

BASIC mode

from the left, (9) MOVE, (8) END, (7) T-UP, (6) /ALM,

(5) AREA, (4) T-RDY, (3) TW-END, (2) CRD and

(1) TIM.

•

ADVANCED mode

from the left, (←) MOVE, (→) END, (9) T-UP,

(8) /ALM, (7) AREA, (6) R-ERR, (5) S-BSY,

(4) M-BSY, (3) R-END, (2) W-END, (1) T-RDY,

(0) TW-END, (.) CRD and (+/-) TIM.

(STOP)

∗ is displayed if the input is active.

• is displayed if the input is non-active.

FREE

(START)

+LS

∗ is displayed if the input is active.

• is displayed if the input is non-active.

−LS

HOME

SLIT

The status of all DIOs can be checked.

∗ is displayed if the input is active.

S-IN

• is displayed if the input is non-active.

The IN (inputs) are, from the left, (STOP), FREE and

(START).

The S-IN are, from the left, +LS, −LS, HOME and

SLIT.

(OUT1)

Press the F4 to change the status of OUT1 to ON

F4: ON/OFF

or OFF.

(MBC)

Press the F4 to change the status of MBC to ON

F4: ON/OFF

or OFF.

(OUT)

It is possible to switch each signal between ON and

OFF state by pressing the specified numerical key.

From the left, (9) OUT1 and (8) MBC.

ASG/BSG

Encoder pulse output is displayed.

∗ is displayed while pulse is being output.

(w0)

The values in the remote registers RWw0 to RWw3

(w1)

are displayed.

(w2)

(w3)

(w4)

The values in the remote registers RWw4 to RWw7

(w5)

are displayed.

(w6)

(w7)

(r0)