Table of Contents
Advertisement
Monitor item
I/O
RIO
RX
DIO
In1
S-IN
ALL
(OUT1)
(OUT2)
(OUTA)
Enc
(RW)
(RWw1)
(RWr1)
(RWr2)
(RWr3)
(RWr4)
Display
ALL
It is possible to switch each signal between ON and
OFF state by pressing the specified numerical key.
•
BASIC mode
from the left, (9) MOVE, (8) END, (7) T-UP, (6) /ALM,
(5) AREA, (4) CRD and (3) TIM.
•
ADVANCED mode
from the left, (9) MOVE, (8) END, (7) T-UP, (6) /ALM,
(5) AREA, (4) R-ERR, (3) S-BSY, (2) R-END,
(1) W-END, (0) CRD and (.) TIM.
(STOP)
∗ is displayed if the input is active.
• is displayed if the input is non-active.
FREE
(START)
+LS
∗ is displayed if the input is active.
• is displayed if the input is non-active.
−LS
HOME
SLIT
IN
The status of all DIOs can be checked.
∗ is displayed if the input is active.
S-IN
• is displayed if the input is non-active.
The IN (inputs) are, from the left, (STOP), FREE and
(START).
The S-IN are, from the left, +LS, −LS, HOME and
SLIT.
(OUT1)
Press the F4 to change the status of OUT1 to ON
F4: ON/OFF
or OFF.
(MBC)
Press the F4 to change the status of MBC to ON
F4: ON/OFF
or OFF.
(OUT)
It is possible to switch each signal between ON and
OFF state by pressing the specified numerical key.
From the left, (9) OUT1 and (8) MBC.
ASG/BSG
Encoder pulse output is displayed.
∗ is displayed while pulse is being output.
(w0)
The values in the remote registers RWw0 to RWw3
(w1)
are displayed.
(w2)
(w3)
(r0)
Use the numerical keys and F4 to change the
value in the RWr0.
(r1)
Use the numerical keys and F4 to change the
value in the RWr1.
(r2)
Use the numerical keys and F4 to change the
value in the RWr2.
(r3)
Use the numerical keys and F4 to change the
value in the RWr3.
8 Manual operation and I/O checking
Description
Display range
∗
•
∗
•
∗
•
00～63
0：OFF
1：ON
＊
・
∗
•
∗
•
∗
•
∗
•
0000h to FFFFh
0000h to FFFFh
0000h to FFFFh
0000h to FFFFh
0000h to FFFFh
−47−
Advertisement
Table of Contents
