Orientalmotor alphaSTEP ARL Series Setting Manual page 20

5 Creating and editing operating data
Deleting data
The following operation deletes a data number previously set.
The subsequent data numbers are automatically decremented by one.
1.
2.
3.
Clearing all operating data
The following operation deletes all operation data and resets the settings to their defaults.
1.
2.
3.
−20−
Select the data number you want to delete in the first screen
of the program mode.
Use the ↑ , ↓ , ←
data number using the numerical keys.
Pressing the the ↑ and
increase and decrease, respectively.
Pressing the ← and →
increase and decrease, respectively.
Press F4 (Del) to select deleting the data.
The message is displayed.
Press the F3 (Yes), and then press the
The data is deleted and the subsequent data numbers are
decremented by one.
After the deletion, the display returns to the first screen of the
program mode.
Do not disconnect the teaching pendant cable while data is being deleted.
Note
Disconnecting the cable while data deletion is still in progress may cause a memory
error.
Press the SHIFT in the first screen of the program
mode.
Hold down the SHIFT , and press the
The message is diplayed.
Press the F3 (Yes), and then press the
All data is deleted and the display returns to the first screen of the
program mode.
Do not disconnect the teaching pendant cable while data is being cleared.
Note
Disconnecting the cable while data clear is still in progress may cause a memory
error.
and → , or directly enter the
causes the number of tens to
↓
causes the number of units to
ENT .
F2 (Aclr).
ENT .