Table of Contents
Advertisement
Positioning operation
1.
Press the
F4
(Opr) in the first screen of the test mode.
The positioning operation execution screen is displayed.
2.
Press the
F3
(PRE) to set the current position in the preset memory.
Selecting preset sets the current position to the position set by the I/O parameter
Note
"PRESET position". Once a preset position is set, positioning operation will be
performed based on the PRESET position.
3.
Press the
F4
(HOME) to start the return-to-home operation.
4.
Select the data No. you want to perform the positioning operation.
Press the
↑ ,
↓
number using the numerical keys.
Pressing the the ↑
Pressing the
←
and
No.25
No.14
No.15
No.05
5.
Press the
START .
The positioning operation using the data of the selected data No. is started.
STOP
Press the
to cancel the positioning operation.
6.
Press the
ESC
to end the positioning operation.
The display will return to the first screen of the test mode.
,
← or
to select the data number. It is also possible to select a data
→
and
↓
causes the number of tens to increase and decrease, respectively.
→
causes the number of units to increase and decrease, respectively.
No.16
8 Manual operation and I/O checking
−43−
Advertisement
Table of Contents
