Orientalmotor alphaSTEP ARL Series Setting Manual page 26

6 Setting parameters
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
−26−
Press either the ← or
PRESET, and press the
The preset position setting screen is displayed.
Enter the preset position using the numerical keys, and
press the ENT .
The minimum ON time of MOVE setting screen is displayed.
Enter the minimum ON time of MOVE using the numerical
keys, and press the ENT .
In the BASIC mode, the LS detection enable/disable setting
screen is displayed. Go to step 11.
In the ADVANCED mode, the OUT1 output setting screen is
displayed.
none: No output
MOVE, END, T-UP, ALM, AREA, TIM
Press either the ← or
want to output as OUT1, and press the
The LS detection enable/disable setting screen is displayed.
Press either the ← or
enable/disable, and press the
If 1 station is occupied, the LS input logic setting screen is
displayed. Go to step 13.
If 2 stations are occupied, the LS input mode screen is displayed.
DIO: The Sensor/User I/O "±LS" input is enabled.
RIO: The remote I/O "±LS" is enabled.
Press either the ← or
and press the ENT .
The LS input logic setting screen is displayed.
Press either the ← or
press the ENT .
The HOMELS input setting screen is displayed.
Press either the ← or
and press the ENT .
The SLIT logic setting screen is displayed.
Press either the ← or
press the ENT .
The overtravel action setting screen is displayed.
Imd stop : Immediate stop
Dec stop : Deceleration stop
Press either the ← or
and press the ENT .
The display will return to the START input mode screen.
to select a HOME or
→
ENT .
to select the signal you
→
ENT .
to select a LS detection
→
ENT .
to select a LS input mode,
→
→ to select a LS logic, and
to select a HOMELS logic,
→
→ to select a SLIT logic, and
to select a overtravel action,
→