System Precautions; Tools Required - Sun Microsystems SPARCclassic Service Manual

Caution - Improper handling by unqualified personnel can cause serious damage to
this equipment. Unqualified personnel who tamper with this equipment may be held
liable for any resulting damage to the equipment.
Caution -
Hot surface. Avoid contact. Surfaces are hot and may cause personal
injury if touched.

System Precautions

Individuals who service this equipment must observe all safety precautions and
ensure compliance with skill level requirements, certification, and all applicable local
and national laws.
Procedures contained in this document must be performed by trained maintenance
providers. Only people who have been trained at the Sun Microsystems
facilities (or at Sun Microsystems affiliates) and have been certified as required by
local and national laws are considered qualified.
Caution - Before you begin, carefully read each of the procedures in this manual. If
you have not performed similar operations on comparable equipment, do not attempt
to perform these procedures.

Tools Required

To remove and replace customer replaceable units (CRUs), you will need the
following tools and materials:
4 Small Phillips-head screwdriver
4 Small flat-blade screwdriver
4 Wrist strap
4 Antistatic surface
4 Volt Ohmmeter (VOM) for checking voltages and continuity
4 Needlenose pliers
4 Conductive foam to store chips
4 Container for screws
®®
training
Safety and Tools Requirements
43