Table of Contents
Advertisement
5550/5517 LCD Menu Adjustments
Four types of LCD screens have been used to manufacture 5550 and 5517 video units. Refer to the
appropriate menu button arrangement below for tips on navigating the menu.
1) Turns the monitor power on or off.
2) Not used.
3) Used to enter the OSD menu, select menu items and accept changes to setting values.
4) Used to move down a line in a submenu or to decrease a setting value.
5) Used to move up a line in a submenu or to increase a setting value.
Tip: Selecting "Factory Default" from the main menu returns all settings to their factory values.
1
2
3
4
5
1) When not in the OSD menu: Toggles between the possible monitor inputs (AV-SV-VGA). It must
be set to AV.
When in the OSD menu: Used to move up a line in a submenu or to increase a setting value.
2) Used to enter the OSD menu, select menu items and accept changes to setting values.
3) Used to move down a line in a submenu or to decrease a setting value.
4) Not used.
5) Not used.
Tip: Selecting "Reset" from the Misc. menu returns all settings to their factory values.
A remote control (B6724) can be used to adjust this LCD without removing the cover from the unit.
1) Used to move up in menus and sub menus.
2) Used to move down in menus and sub menus.
3) Used to enter or exit the OSD menu and accept changes to setting values.
4) Used to enter into menus and sub menus and increase setting values.
5) Used to enter into menus and sub menus and decrease setting values.
Tip: Selecting "Reset" from the function menu returns all settings to their factory values.
1) Used to move up a line in a menu / submenu and to increase a setting value.
2) Used to enter the OSD menu, select menu / submenu items and accept changes to setting values.
3) Used to move down a line in a menu / submenu and to decrease a setting value.
4) Not used – this button may not be installed on the menu board.
Tip: Selecting "Reset" from the Misc menu returns all settings to their factory values. Note that the
menu will not display if no input signal is present.
26
This menu board is located below the LCD screen. A dual
color LED on the right side of the board indicates power
status: green = on & red = standby.
This menu board is located at the top left of the video unit at an angle.
This menu board is located below the LCD screen. A green power
LED is on the left side of the board.
This menu board is located on the plate on the back of the
LCD screen.
08-315 (3/6/12)
Advertisement
Table of Contents
