Table of Contents
Advertisement
Cat 5 Lane Speaker/Driver Kit Installation
The Cat 5 Lane Speaker Driver Kit (E0958-KIT) allows for the use of Cat 5 cable from the matrix to the
customer lane for distances up to 1000 feet. Cat 5e & Cat 6 may also be used. This kit can also be used
with standard E0680 audio cable to correct problems caused from excessive cable length.
Install the E0958 enclosure inside the customer unit in a convenient location.
Attach the cable from the matrix to the RJ-45 connector (J3) per Figure 4.
Attach the lane speaker, microphone & call button to the 8 pin connector (J2).
Plug the 12VDC power supply into J1 (center pin positive) and into a 110VAC outlet in the unit. * If
12VDC is already available in the unit, the E0958 board can be powered at the 12VDC terminals of
connector J2. DO NOT connect power to both J1 & J2. Use one method or the other.
Set R1 on the E0958 board to maximum volume (fully counter-clockwise) and set the speaker gain
pot on the matrix to 9:00. Only increase the speaker gain at the matrix if necessary and then in small
30 minute increments and retest. The E0958 board will boost the volume at the lane so keep the
speaker pot at the matrix as low as possible. The lane microphone adjustment is made at the matrix
as usual. (See the section "Adjusting the Audio System" later in this document.)
08-315 (3/6/12)
Figure 4
7
Advertisement
Table of Contents
