Lane Speaker/Driver Kit Installation - Hamilton Air 5000 Series Installation & Service Manual

Lane Speaker/Driver Kit Installation

The Lane Speaker Driver Kit (E0892-KIT) is discontinued and is replaced by the E0958-KIT shown on
the next page. The E0958-KIT can be used with standard audio cable or Cat 5 cable. The E0892-KIT is
shown here for existing service purposes only. Audio cable from the matrix to the customer lane is
typically limited to approximately 180 feet with 16AWG speaker wire due to the resistance of the wire.
The Lane Speaker Driver Kit (E0892-KIT) allows the distance to be extended to a maximum of 1000
feet using standard E0680 audio cable.
Install the E0892 enclosure inside the customer unit in a convenient location.
Attach the cable from the matrix to the 7 pin connector (J2) per Figure 3.
Attach the lane speaker, microphone & call button to the 8 pin connector (J1).
Plug the 12VDC power supply into P1 (center pin positive) and into a 110VAC outlet in the unit.
The power LED (CR1) will light. * If 12VDC is already available in the unit, the E0892 board can
be powered at the 12VDC terminals of connector J1. DO NOT connect power to both P1 & J1. Use
one method or the other.
Adjust the speaker & microphone gain pots on the matrix for proper volume levels. (See the section
"Adjusting the Audio System" later in this document.)
6
Figure 3
08-315 (3/6/12)