Table of Contents
Advertisement
5012 Remote Handset Installation
The 5012 Remote Handset has been replaced with the 5512 but is described here for service purposes.
With the 5012, removing the handset from its cradle initiates a Teller Call and disconnects the remote
station speaker and microphone. The 5012 is equipped with a hearing-aid compatible receiver.
Important Note: The handset used with the 5012 is different from the 5512 handset. If the actual
handset is swapped to the other model of unit, it will not work.
Model 5012H is mounted on the left side of pneumatic tube drive-up units, while Model 5012W is
designed for wall mounting, such as in lobby applications. These units can be used outdoors but should
be protected from rain.
Installation
Remove the cover from the 5012.
(Pneumatic unit mount only) – Determine a suitable location for the 5012H on the left side of the
pneumatic unit clear of its internal components and within easy reach of customers. Affix the
enclosed drilling template on the side of the pneumatic unit and drill the 5 holes. Secure the 5012H
to the pneumatic unit using appropriate hardware.
(Wall mount) – Secure the 5012W to the mounting surface using appropriate hardware.
Connect the paired pigtail cable exiting the 5012 to the remote station speaker, microphone and call
button according to the chart in Figure 8 on the previous page. The 5012 may be used alone without
a remote station speaker, microphone and call button by not using this pigtail cable. It can be
unplugged and removed but should be saved for possible future needs.
Pass the cable coming from the audio matrix through the cable port of the 5012 and connect it to the
5012 MATRIX terminal block. Unplug the connector to read the terminal labeling on the board. The
pinout is the same as at the
matrix lane connector and is
shown in Figure 10.
Connect a source of 24VAC or
12VDC to the 3 pin connector
on the 5012 board. Unplug the
connector to read the pinout.
For 24VAC use terminals 2 &
3. For 12VDC, terminal 1 is
positive and terminal 2 is
negative. If a source is not
available, use part number
E0947 for a 12VDC / 1A power
supply.
If the 5012 is not mounted on a grounded electrical box or surface, connect the green wire to one of
its mounting screws. Otherwise, cut off and discard the green wire.
Reinstall the 5012 cover, taking care that no wires are pinched or interfere with the hook-switch
mechanism or contacts. Hang up the handset.
Adjust the speaker and microphone gain pots on the matrix while using the remote speaker and
microphone, not the handset. (See the section "Adjusting the Audio System" later in this document.)
Lift the handset from its cradle – a Teller Call tone is generated. Use the pots on the 5012 board if
necessary to balance the handset volumes with the remote speaker and microphone volumes.
08-315 (3/6/12)
AUDIO MATRIX
-SP+
-TC+
-MC+ SHLD
Figure 10
P1
BLACK
SP-
WHITE
SP+
BLACK
TC-
GREEN
TC+
BLACK
MC-
RED
MC+
SHIELD
5012 MATRIX
11
Advertisement
Table of Contents
