Table of Contents
Advertisement
E0465-3WD-LP License Plate Camera Kit Installation
The following instructions are for mounting the License Plate Camera assembly on the back side of a
5517 Video Unit. This camera is used for viewing the rear license plate of a vehicle as it leaves the
drive-up lane. It can be oriented to view the vehicle in the same lane as the 5517 it is attached to or the
vehicle in the previous lane simply by shifting the camera housing 90° on it's bracket. See the photos in
Figure 32.
1) Remove the cover from the License Plate Camera assembly by
removing the 2 screws from the rear of the housing. Pull the
video/power cable up through the housing so it is no longer
passing through the square tube on the bottom.
2) Remove the plastic end cap from the outer end of the 5517
mounting bracket.
3) Insert the square tube of the License Plate Camera assembly
into the end of the 5517 bracket. While holding the
assembly in place, drill a hole through the bottom of the
5517 bracket up through the inner bracket using a #29 or
1/8" drill bit. This hole will be used later to hold the
assembly in place but for now remove the assembly.
4) A power converter is provided with the kit which converts
24VAC from the pneumatic unit to 12VDC for the new
camera. Feed the barrel connector end of the power
converter along with a video cable from inside the
pneumatic unit up through and out the end of the 5517
mounting bracket.
5) Temporarily feed the power cable through the License Plate
Camera bracket so it can be connected to the camera power
cable. Slide the assembly back into the 5517 bracket. It will
be necessary to slightly push the new video cable back into
the bracket.
6) Connect the power converter input wires to the 24VAC
terminals of the pneumatic unit.
7) Connect a service monitor to the video pigtail which is still
hanging out the top side of the License Plate Camera
assembly. Adjust the camera bracket as necessary to get the
proper view.
8) Disconnect the service monitor and power cables from the
License Plate Camera pigtail and remove the assembly.
9) Feed the video/power pigtail cable back through the License
Plate Camera bracket like it was initially and re-install the
cover.
10) Attach the pigtail to the video and power cables and insert the
License Plate Camera bracket back into the 5517 bracket.
Secure it in place with the #8 x 3/8" stainless steel screw
included with the kit.
11) Connect the remote end of the new video cable and check the
new camera for proper operation.
08-315 (3/6/12)
Figure 32
Backside of 5517 Video Unit
Drill Hole Here
Oriented for Viewing
the Previous Lane
Oriented for Viewing
the Same Lane as 5517
Where Installed
27
Advertisement
Table of Contents
