Table of Contents
Advertisement
5550 (Original Style) Teller Video Unit Installation
The following instructions are for the original style 5550 that contains both a camera and monitor for
two-way video. The 5550-1 is the same unit without a camera installed for one-way video.
Assembly
The 5550 is shipped fully assembled except for the base. Remove the 4 screws from the bottom of
the stand and attach the base so the forks are pointed toward the front of the unit.
Optional 5550 Swivel Kit (B6075)
Note that the 5550 Swivel Kit is an optional accessory and is not included with the 5550 video unit.
Remove the (4) round-head screws from the bottom of the video unit base and separate the base
from the stand. These screws will not be reused.
Refer to the top photo in Figure 24 for attaching the swivel kit mounting plate to the video unit stand
using the (4) flat-head screws provided in the kit. Note that the ¼-20 threaded stud is offset from the
center of the plate. Be sure to orient the plate so the stud location matches the hole in the base.
Refer to the bottom photo in Figure 24 for attaching the base to the plate. Note that the pictures show
the stand and base upside down for clarity. The nylon washers are on each side of the base and the
metal washer is next to the ¼-20 locknut as shown.
Tighten the locknut to obtain the desired amount of swivel tension.
Video & Power Connections
Using 75 ohm CCTV coax (Belden 1426A or equivalent) with BNC connectors at each end, connect
the camera and monitor to the video matrix (see Figures 2 & 25). Make sure to match up the audio
and video port numbers at the matrixes. For example if the audio console is connected to Console 1
of the audio matrix, then the video cables from that same teller position must be connected to
Console 1 of the video matrix.
08-315 (3/6/12)
Figure 24
¼ - 20 Locknut
Base Will Install Between Nylon Washers
Swivel Kit Mounting Plate
Flathead Screws (4)
Video Unit Stand
Bottom View With Swivel Kit Installed
19
Advertisement
Table of Contents
