Table of Contents
Advertisement
E0885 Video Power Control Kit Installation
The E0885 kit should only be used to control the power through the relay boards in the 5517 video units
as shown. DO NOT attempt to power video units directly with the power control kit. Follow the wiring
diagram in Figure 28. Wire gauge for the relay trigger wires is not critical since the current draw for
each relay coil is only 22ma. Be sure to follow the color code when connecting the lighted switch to the
control board. The switch can be mounted in any suitable location in the teller area.
Figure 28
Important Note: Newer Hamilton Air units that have an E0873 I/O Control Board do not require the
Video Power Control Kit. For these units use a Video Power Control Cable (E10036) to connect the I/O
Board in the pneumatic unit to the Relay Board in the 5517. The 3 pin connector on one end of the cable
connects to J15 on the I/O Board and the 2 pin connector on the other end of the cable connects to J3 of
the Relay Board in the 5517. The Night Lock switch for the pneumatic unit will control the power to the
relay coil which in turn will control power to the LCD Monitor.
08-315 (3/6/12)
23
Advertisement
Table of Contents
