Table of Contents
Advertisement
pneumatic unit and then install the end caps from the accessory bag into both ends of the mounting
arm.
Plug the power supply into a 110VAC outlet.
Tilt the camera vertically in its bracket to achieve the desired viewing angle. To view the image,
temporarily connect a service monitor to the "camera" BNC connector in place of your interconnect
cable. If a service monitor is not available it will be necessary to use the 5517 monitor. In this case
reconnect the video and power cables to the LCD. The yellow RCA connector is for video. Place the
unit in "service" mode by placing the service switch at the upper left of the video head to the rear
position. This will connect the camera video directly to the monitor. Note: If the video power control
kit in the teller area is not yet installed or turned on, it will be necessary to temporarily move the
video power wires from the switched to the un-switched terminals of the relay board to test the video
unit (see Figure 28).
The camera has been adjusted at the factory but a menu board (only available on later units)
attached to the rear mounting plate allows camera settings to be changed if needed. See Figure 23 for
an explanation of the menu buttons. Use the service switch in the 5517 if necessary to connect the
camera directly to the monitor for viewing the menu. If focusing is required, loosen the small set
screw and then rotate the lens to the desired focus. Snug the set screw when finished but do not over
tighten to avoid creating a dimple in the lens threads making future fine adjustments difficult.
The monitor has been pre-adjusted at the factory but a menu board allows settings to be changed.
The menu board is located on the rear of the LCD mounting plate for current versions. With older
versions the menu board was above the upper left of the LCD or below the LCD screen. See the
section "5550/5517 LCD Menu Adjustments" for more information. Important note for units that
have the menu board above the upper left of the LCD – the far left button changes the type of input
that the LCD is expecting. Since it is very close to the monitor BNC connector and the service switch
it is possible to accidentally bump the button which would change the input. If a blue box appears on
the screen with the message "VGA No Signal" or "SV No Signal", press the left button to change
the input back to AV.
Once all adjustments are satisfactory, place the unit in "normal" mode by placing the service switch
to the forward position. Make sure the video and power cables are connected to the LCD (the
"yellow" RCA connector is for video) and replace the front cover, securing with all the screws. Two
of the screws are security type. A driver bit is included for the security screws.
22
08-315 (3/6/12)
Advertisement
Table of Contents
