Table of Contents
Advertisement
Matrix / System Wiring Diagram
Refer to Figure 2 for standard wiring connections. The drawing shows a 4-lane matrix but the same
wiring applies to all versions. Observe the following guidelines.
The ground wire connection shown for the audio matrix is not required for the 5003 matrix.
Be sure to only connect the drain wire for the microphone pair at the matrix end as shown.
For audio-only systems the audio console(s) may be plugged into any of the console ports of the
audio matrix. When video is used the console ports must match for a particular teller position.
For example if the audio console is plugged into CONSOLE 1 of the audio matrix, the camera
and monitor for that same teller must be plugged into CONSOLE 1 of the video matrix.
If auxiliary audio is used and the source only has a mono output, it may be plugged into either
the L or R connector on the audio matrix. The LEVEL pot adjusts the volume of the aux audio.
The auxiliary video source must provide composite video which is the same as the output from a
CCTV camera.
08-315 (3/6/12)
Figure 2
5
Advertisement
Table of Contents
