Table of Contents
Advertisement
Description
The 5000 Series system consists of components that allow 2-way audio and video communications
between server (teller) consoles and customer units in banks, pharmacies and other service
environments. These systems allow both parties to hear and speak at the same time without feedback.
Inside and outside noises, other than speech, are screened out by using sharp cutoff filters to greatly
reduce sound outside the speech range. In addition, background noise cancellation circuitry in all 5000
Series audio consoles samples the incoming audio to the server (teller) using special algorithms to
virtually eliminate consistent, repetitive noise such as vehicle engines and mufflers.
System Configuration
To configure a new system using current components:
1) Start by determining the maximum number of consoles and customer lanes required and select
audio/video matrixes with an adequate number of ports. Note that some audio matrixes are shipped
with power supplies and others require that the power supply be ordered separately. All video
matrixes receive their power from the audio matrix.
Audio Matrix
5003..............1 on 2 (1 server on 2 customers) - includes power supply (see 5501-1 below)
5004..............2 on 2 - includes power supply
5002-4...........3 on 4 - requires power supply E10171
5002-8...........6 on 8 - requires power supply E10171
5002-12.........6 on 12 - requires power supply E10171
Video Matrix
5005-4...........3 on 4
5005-8...........6 on 8
5005-12.........6 on 12
Audio/Video Matrix
5006..............2 on 2 - includes power supply
2) Select the required number and size of audio consoles to meet the number of customer lanes.
5501-2...........2 lane
5501-4...........4 lane
5501-8...........8 lane
5501-12.........12 lane
5501-1...........This is a kit number that includes a 5501-2 audio console with a 5003 matrix.
3) Select the proper number of lane microphones and speakers if these do not already exist. Note that
there are a wide variety of electret microphones on the market and all have different characteristics.
Using an existing microphone may not provide optimum results. Also the system is designed for a 4
ohm speaker. A comparable 8 ohm speaker could be used but the volume would be reduced. Factory
installed microphones and speakers in Hamilton Air units are correct for this system.
E0604............Lane microphone with 48" leads
B4956...........Lane speaker, 4 ohm, 3"
4) If video is being used, select the proper number of teller and customer video units if cameras and
monitors do not already exist.
5550..............Server (Teller) Video Unit - includes stand and power supply
5517..............Customer Remote Video Unit - includes mounting arm and power supply
E0885............Video Power Control Kit (When using 5517's it is also recommended to order
08-315 (3/6/12)
a Video Power Control Kit so the customer monitors, and optionally the
cameras, can be turned off after hours. Only one required per system. This kit is
not necessary for newer Hamilton Air pneumatic units using the E10036 Video
Power Control Cable.)
3
Advertisement
Table of Contents
