Table of Contents
Advertisement
5572/5573 Remote Customer "In Wall" Audio Consoles
Description
The Remote Customer "In Wall" Audio Unit consists of a speaker,
microphone and call button in a recess mount double gang electrical box for
indoor applications (see Figure 14). The model 5572 is intended for use with
standard E0680 audio cable and can be used for cable lengths up to
approximately 180 feet. No remote power is required for the 5572. The model
5573 is used with Cat 5 cable and allows for cable runs up to 1000 feet. A
power supply is included with the 5573 and requires a 110VAC outlet near the
remote location.
Compatibility
The Remote Customer "In Wall" Audio Unit should only be used in systems that
have 5501 or newer 5001 (rev. 5 or 3.1) teller consoles. Also feature switch #7 on the audio matrix must
be set to the UP position (dynamic echo canceller learning). Keep the speaker and mic gain settings on
the matrix to the lowest level which will still allow adequate audio. Avoid using 4001, 4101 or 3001
teller consoles which will result in excessive teller echo.
Installation
Figure 15 shows a side view of the completed assembly before installation.
Remove the front plastic bezel from the unit by pressing the two plastic
tabs on the bottom with a screwdriver. Disconnect the wires from the call
button and set the bezel aside (see Figure 16).
Next remove the four philips head screws and remove the audio assembly
from the electrical box.
Determine the mounting location and cut an opening in the wall for the
double gang electrical box.
Fish the audio cable in the wall and through one of the cable slots in the rear of
the box. The power supply cable must also be installed if using the model
5573. The power supply must be in the vicinity of the 5573 so do not extend the
power supply cable any more than necessary.
Mount the electrical box in the wall by tightening the two screws which pull
the mounting tabs against the rear of the wall.
Attach the cable to the audio assembly. Figure 17 shows the rear of the 5572
and Figure 18 shows the rear of the 5573. Figure 19 shows the wiring of both
units to the audio matrix.
Note that the pot on the 5573 board must be set to the fully counter clockwise
position as shown in Figure 18.
Install the audio assembly in the electrical box using the philips head screws. Make sure the rear
plastic part of the bezel is in place (reference Figure 16). Attach the leads to the call button and then
snap the front bezel into place.
08-315 (3/6/12)
Figure 14
Figure 15
Figure 16
13
Advertisement
Table of Contents
