Table of Contents
Advertisement
5570/5571 Remote Customer Audio Consoles
Description
The 5570 & 5571 Remote Customer Audio Consoles consist of a speaker,
microphone and call button in a desktop type enclosure for indoor
applications (see Figure 11). The 5570 is intended for use with standard audio
cable and can be used for cable lengths up to approximately 180 feet. The
5571 is intended for use with Cat 5 cable and can be used for cable lengths up
to 1000 feet. A 12VDC power supply is included with the 5571 and requires a
110VAC outlet near the remote location.
Figure 11
In addition to free standing, the Remote Customer Audio Console can use the same
mounting options as the 5501 Teller Console. Use the 5501-HWB (Horizontal Wall
Bracket), the 5501-VWB (Vertical Wall Bracket) or the B6077 (Adjustable Desktop Stand) for mounting
flexibility.
Compatibility
The Remote Customer Audio Console should only be used in systems that have 5501 or newer 5001 (rev. 5
or 3.1) teller consoles. Also feature switch #7 on the audio matrix must be set to the UP position (dynamic
echo canceller learning). Avoid using 4001, 4101 or 3001 teller consoles which will result in excessive teller
echo. 3301 teller consoles may be acceptable if the volume levels are kept low.
Installation
Make connections between the audio matrix and the rear of the 5570/5571 using the appropriate cable. Use
standard E0680 audio cable for the 5570 (see Figure 12) and Cat 5 cable (or Cat 5e or Cat 6) for the 5571
(see Figure 13). Use the included power supply to provide 12VDC to the rear of the 5571. The power supply
must be close to the 5571. Do not significantly increase it's cable length. For reference, the center pin of the
power supply barrel connector is positive. A raised tab is provided on the rear of the 5570/5571 to accept a
tie-wrap for cable strain relief if desired.
Figure 12
Figure 13
12
08-315 (3/6/12)
Advertisement
Table of Contents
