Cleaning; Storage; Spare Parts; Disassembly - GARANT VG BASIC Instruction Handbook Manual

Fault
No transillumination.
Counter shows unrealistic co-
ordinates.
Neither quick adjustment nor
fine adjustment functioning.
No printing.
 Panel PC failing to start
up.

11. Cleaning

Disconnect from the power supply before starting cleaning. Clean with a slightly damp cloth. Do not use chemical, alcohol-
based, abrasive or solvent-based cleaners.

12. Storage

After use, cover the unit with the dust cover.
If the unit is to be stored for an extended period, place it in the transport case in a dry place protected from light and dust at
temperatures between +5°C and +40°C and relative atmospheric humidity between 50% and 70%. Protect stored compon-
ents against mechanical shaking and damage.

13. Spare parts

Order original spare parts from the Hoffmann Group Customer Service.

14. Disassembly

i
For safe transport, comply with Transport, place of erection [} Page 41].
1. When closing down the pre-setting device, comply with the settings under Exit and switch off.
2. Use the main switch to switch off the pre-setting device.
3. Disconnect the cable and compressed air connections from the pre-setting device in the reverse sequence to that spe-
cified in chapters power supply [} Page 42] and Compressed air supply [} Page 42].
4. Move the tower and anti-rotation arm to their end positions, and fit the transport restraint for the X-axis and Z-axis.
5. Lift the pre-setting device with one person on the right and one on the left, support the tower to prevent it tipping.
6. Put it down on a Europallet and use the brackets supplied to secure it to the pallet.
7. Fold down the panel PC as far as possible.
8. Rub lubricant (WD-40) into the tool mounting, remove the taper needle roller bearing, fill the tool mounting with oiled
paper.
9. Check the transport restraint plate for the X-axis and Z-axis is correctly seated.
Possible cause
LED defective
Cable open circuit
Switched off in the PCTC soft-
ware
Movement to reference
points failed
Communications problem
with the reading head
Adapter incorrectly created or
incorrect adapter selected
Compressed air not connec-
ted
Drive nut defective
Pinion displaced
 Printer not switched on.
 Not connected to the PC.
 Not selected in the meas-
urement software.
Not yet installed.
 No power supply.
 Loose plug at the PC.
Action
Replace the LED.
Check the plug connections.
Restart the panel PC.
Repeat the movement to ref-
erence points [} Page 43].
Check or clean the magnetic
strip installed in the tower
and the reading head on the
guide rails.
Check adapter data, or recre-
ate or recalibrate it.
Check the compressed air
connections and the service
unit.
Check the drive nuts.
Check the position of the pin-
ion.
 Check all plug connec-
tions.
 Check whether the printer
is selected in the software.
Install the printer.
Check the plug connections
(when power is present, the
green LED on the power sup-
ply unit lights up).
Performed by
Trained person
Trained person
Trained specialist for mechan-
ical work
Trained person
Trained person
www.hoffmann-group.com
de
en
cs
da
es
fi
fr
hr
hu
it
lt
nl
pl
ro
ru
sl
sv
57