Switching On; Pneumatic Connections (Schematic); Performing Movement To Reference Points/Calibration - GARANT VG BASIC Instruction Handbook Manual

6.1.3.

Pneumatic connections (schematic)

X-axis drive nut
Main compressed air supply
(provided by the customer)
at least 4 bar
Fig. 5: Pneumatic connections
6.2.

SWITCHING ON

1. Switch on the main switch at the rear of the base body, and wait 10 seconds.
2. Keep the On/Off switch on the panel PC depressed for two to three seconds.
» The panel PC will start up.
3. If the panel PC fails to start up, wait four to five seconds and once again keep the On/Off switch on the panel PC de-
pressed for two to three seconds.
» The measurement software will start, note the Performing movement to reference points/calibration [} Page 43].
6.3.

PERFORMING MOVEMENT TO REFERENCE POINTS/CALIBRATION

i
Calibration is necessary in order to determine the offset values for the adapter/calibration mandrel.
 After every restart,
 after changes to the parameters,
 after changing the adapter.
Z-axis drive nut
Internal service unit
Handle
Valve
Pneumatic connections
www.hoffmann-group.com
de
en
cs
da
es
fi
fr
hr
hu
it
lt
nl
pl
ro
ru
sl
sv
43