Honda V65 MAGNA 1985 Manual page 264

FRONT WHEEL/SUSPENSION
sPRING SEAT PISTON
\
CIRCLIP OIL LOCK VALVE VALVE SPRING
HEX WRENCH, 6 mm 07917-3230000
OR COMMERCIALLY AVAILABLE IN U.S.A.
losen the rebound spring and piston into the fork
tUbe.
On the left fork, install the spring seat, valve spring,
Oil lock valve. and circlip on the piston.
Place the oil lock piece on the end of the piSlon
and insert the fork tube into the slider.
Temporarily install the fork spring and fork
tube
cap to tighten the socket
bolt.
Plaett the fork slider in a vise with soft jaws or a
shop towel.
Apply a locking agent to the socket bolt and thread
it into the piston. Tighten with a 6 mm hex wrench.
TORQUE: 15-25 N·m 11.5-2.5 kg,m. 11-18 ft·lb)
NOTE:
PI&CfI the slider bushing over the fork tube and rest
it on the slider. Put the back·up ring and an old
bushing or equivalent tool on top.
Drive the bushing into place with the seal driver and
remove the old bushing or equivalent tool.
Coat a
new
oil seal with ATF and install it with
the seal markings facing up. Drive the seal in with
the seal driver.
FORK SEAL DRIVER
07947-KA50100
FORK SEAL DRIVER ATTACHMENT
07947-KFOO100
15-34