Honda V65 MAGNA 1985 Manual page 162

CYLINDER HEAD/VALVE
Turn the crankshaft until there is maximum cam
chain free play, then install the oil pipes under the
cam chain.
Install the cam chain guide on t.he oil pipe base
plate.
Tighten the cylinder head 10 mm bolts in a criss-
cross pattern in 2-3 steps.
TORQUE: 48-52 N·m (4.8-5.2 kg-m, 35-38 ft·lb)
Tighten the cylinder head 8 mm bolts in a crisscross
pattern in 2-3 steps.
TORQUE: 21-25 N·m (2.1-2.5
kg-m.
15-18
ft-Ib)
Tighten the cam shaft holder 6 mm bolts.
TORQUE: 10-14 N·m f1.0-1.4 kg-m. 7-10 ft-Ibl
Lubricate the cam lobes with oil.
Adjust the valve clearance (page 3-9).
Inspect the cylinder head cover gasket for damage
or deterioration.
NOTE:
Clean the gasket before applying seatant.
Apply sealant of the head cover gasket.
Install the front cylinder head cover and gasket.
Install the rear cylinder head cover base cover, and
gaskets. Be sure that the arrow casting on the rear
head cover faces the front of the engine.
Install the remaining parts in the reverse order of
removal.
.CAM CHAIN GUIDE
ARROW CASTING
10-24
HEAD COVER BASE REAR HEAD COVER