Honda V65 MAGNA 1985 Manual page 169

CRANKCASE
Tighten the UPPfr crankcase bolts to the specified
torque in a crisscross panero and in 2-3 steps.
TORQUE: 8 mm: 21-25 N·m
12.1-2.5 kg.m, 15-18 ft.Jbl
6 mm: 10-14 N·m
(1.0-1.4 kg-m, 7-10 ft-lbl
Install the gearshift indicator switch.
Install the rnainshaft bearing holder and ti~ten the
screw and bolts.
Install
8
new output gear case gasket with one of
the same thickness as removed.
NOTE:
Early production engines had gaskets that
were not marked.
The gasket is crushed 0.05 mm when the
output gear case is installed.
Install the output gear else with a new gasket.
tnstall the bolts and then tighten to the specified
torque.
TORQUES:
8 mm lOCket bolts:
21-25 N·m (2.1-2.5 kfl"m, 15-18 ft·lb)
6mmBOLT
8 mm FLANGE BOLTS
11-6
GmmFLANGEBOlTS 8 mm SOCKET SOLTS