Honda V65 MAGNA 1985 Manual page 4

1. GENERAL INFORMATION
~~ENERAL
SAFETY
..
_ - - - -
II]
1-1
SERVICE RULES
1-1
MODEL IDENTIFICATION
1-2
SPECIFICATIONS 1-3
TOROUE VALUES
1-5
TOOLS
1-7
CABLE & HARNESS ROUTING
1-9
EMISSION CONTROL SYSTEM 1-17
- ---
----
GENERAL SAFETY
fmm
If the
~ng;n~
must
In
running 10 do
som~
work.
nwu
sun>
th~ ~Il
;s
~J/·Ii~ntillJltd. Ne.t-~,
run
th~ ~nrine
in a closed
aTN. The UMUSI
~onttJjns
poisonous corbon monoxide
IllS.
fmm
Gawlint' is uruml'ly flammable
lind
is t'xplosivt'
under
entain conditions. Do not smoke or aI/ow flames or sparks
in your working area.
SERVICE RULES
The boUt'r)' Idecuolytt ('(mtains sulfuric acid. Prot«t your
eye.~, .~in, and dmhinf(. In ('o~
of contoN, flush thorough-
~v
wi,h
"''iller
Qnd
roll 0 (fOI:I"r IJ
f'1f'('''O~l''t'
gels in your
t:1't'X
m.!;W!m~
The ballery generous hydrogen gas which can
f),
highly
t'xplosilll', Do nO/ smokt' or allow flames or sparks near the
bOIll'ty, especially while charging it.
Use genuine HONDA or HONDA-recommended parts and lubricants or their
equi~alent.
Parts
th~t
do not meet HONDA's
design specifications may damage the motorcycle.
2. Use the special tools designed for this product.
3. Use only metric tools when
ser~icing
this motorcycle. Metric bolts, nuts, and SCfews afe not interchangeable with English
fasteners. The use of incorrect 10015 and fasteners may damage the motorcycle.
4. Install new gaskets. O·rings. cotter pins, lock plates, etc. when reassembling.
5.
When tightening bolts or nuts. begin with
larger~iameter
or inner bolts first. and tighten to the specified torque diagonally,
unless a particular sequence is specified.
6. Clean paris in cleaning
sol~ent
upon dlS<tssembly. Lubricate any sliding surfaces before reassemblv.
7_ After reassembly. Chtck all paru for proper Installation and operation.
8. Roule all electrK:al wires as shown on pages 1-9 Ihrough 1-16 Cable ann ~arness Routing_
1 -1