Table of Contents
Advertisement
Chapter 3 Basic Operations — Operating with the remote control
Switching the display position of the menu screen
By directly calling up the [ON‑SCREEN DISPLAY] screen without operating from the main menu screen, the
display position of the menu screen (OSD) can be easily changed.
button
1)
Press and hold the <ON SCREEN> button for at least one second.
f The [ON‑SCREEN DISPLAY] screen is displayed while the cursor is in [OSD POSITION] state.
2)
Press qw to switch the [OSD POSITION] setting.
f The display position of the menu screen (OSD) will switch each time you press qw.
Note
f Display position of the menu screen (OSD) can also be changed with the menu operation. For details, refer to "Setting [OSD POSITION]"
(x page 143).
Using the function button
By assigning the following functions to the <FUNCTION> button, it can be used as a simplified shortcut button.
[SUB MEMORY], [SYSTEM SELECTOR], [SYSTEM DAYLIGHT VIEW], [FREEZE], [WAVEFORM MONITOR],
[LENS MEMORY LOAD], [ASPECT], [PROJECTION METHOD], [GEOMETRY], [ANGLE INFORMATION]
button
1)
Press the <FUNCTION> button.
Note
f Assignment of the function is performed from the [PROJECTOR SETUP] menu → [FUNCTION BUTTON] (x page 182).
The [FUNCTION BUTTON] screen can also be displayed by holding down the <FUNCTION> button on the remote control.
Displaying test patterns
To check the condition of the projector, ten internal test patterns and up to three user registered test patterns can
be displayed.
button
1)
Press the <TEST PATTERN> button.
f The test pattern and the main menu screen is displayed.
f If the [TEST PATTERN] screen (list format) is displayed, proceed to Step 3).
2)
Press the <TEST PATTERN> button again.
f The test pattern and the [TEST PATTERN] screen (list format) are displayed.
f The [TEST PATTERN] screen (list format) can also be displayed by pressing the <ENTER> button while
[TEST PATTERN] is selected in the main menu screen.
3)
Press as to select the test pattern to display, and press the <ENTER> button.
f Selected test pattern and the [TEST PATTERN] screen (toggle selection format) are displayed.
f To change the test pattern, proceed to Step 4).
4)
Press qw to switch the test pattern.
f The test pattern will switch each time you press qw.
Note
f The main menu screen and the [TEST PATTERN] screen (list format, toggle selection format) can be hidden by pressing the <ON
SCREEN> button on the remote control while the test pattern is displayed.
f Test patterns can also be displayed using the menu operation. Refer to "[TEST PATTERN] menu" (x page 193) for details.
f Settings of position, size, and other factors will not be reflected in test patterns. Make sure to display the input signal before performing
various adjustments.
ENGLISH - 89
Advertisement
Table of Contents
