Table of Contents
Advertisement
[OFF]
[1]
[2]
[3]
[USER]
f Proceed to Step 4) when [1], [2], or [3] is selected.
4)
Press the <ENTER> button.
f The [DYNAMIC CONTRAST] screen is displayed.
5)
Press as to select the item to set.
f When [CONTRAST MODE] is selected, the items will switch each time you press qw.
f When [MULTI PROJECTOR SYNC] is selected, press the <ENTER> button.
[CONTRAST MODE]
(Correction mode setting)
[MULTI PROJECTOR SYNC]
Note
f Always use the contrast synchronization function when combining the projected images from multiple projectors to display a single image.
f The contrast synchronization function will operate when all of the following conditions are fulfilled.
g All the projectors to be linked are connected in a loop with the daisy chain connection. (Maximum 64 projectors)
g [MODE] of [MULTI PROJECTOR SYNC] on only one projector that is linked is set to [MAIN], and [MODE] on all other projectors are set to
[SUB].
g [CONTRAST SYNC] on the projectors to perform the contrast synchronization is set to [ON].
g If all linked projectors have the [CONTRAST MODE] setting menu, the [CONTRAST MODE] setting is unified to [1] or [2], regardless of
the [CONTRAST SYNC] setting.
g If there is any projector that does not have the [CONTRAST MODE] setting menu, the [CONTRAST MODE] setting is unified to [1],
regardless of the [CONTRAST SYNC] setting.
Performing desired correction
1)
Press as to select [DYNAMIC CONTRAST].
2)
Press qw.
f The [DYNAMIC CONTRAST] individual adjustment screen is displayed.
3)
Press qw to select [USER].
4)
Press the <ENTER> button.
f The [DYNAMIC CONTRAST] screen is displayed.
5)
Press as to select the item to set.
f The items of the detailed settings will switch each time you press qw.
f Press the <ENTER> button when [MULTI PROJECTOR SYNC] is selected.
104 - ENGLISH
Chapter 4 Settings — [PICTURE] menu
Disables the dynamic contrast function.
Adjusts the light source and compensates signals to a small extent.
Adjusts the light source and compensates signals to a moderate extent.
Adjusts the light source and compensates signals to a large extent.
Set any desired correction.
Refer to "Performing desired correction" (x page 104) for details.
Setting item
[1]
[2]
Details
Select this item when misadjusted black level (grayish black) is
bothersome in the dark scenes.
Performs conventional correction to adjust the black level by
decreasing the general brightness.
Select this item when topical radiance is required even in dark
scenes.
Performs standard correction of the projector that does not
decrease the brightness too much.
(Factory default setting)
Sets the contrast synchronization function.
This setting item is common with the following menu item.
f The [PROJECTOR SETUP] menu → [MULTI PROJECTOR
SYNC]
For details, refer to the [PROJECTOR SETUP] menu → [MULTI
PROJECTOR SYNC] (x page 177).
Advertisement
Table of Contents
