[Slot Setting] - Panasonic PT-REQ10 Operating Instructions Manual

[SLOT SETTING]

Set the power supply to the slot.
The content that can be set varies depending on the Function Board installed in the slot. This cannot be set when
the Function Board is not installed.
[SLOT STANDBY]
Set the power supply during the standby mode.
1) Press as to select [SLOT STANDBY].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[ENABLE]
[DISABLE]
Note
f [SLOT STANDBY] is fixed to [DISABLE] when the following Function Board is installed.
g 12G-SDI Terminal Board (Model No.: TY-SB01QS)
g Function Board for 12G-SDI Optical (Model No.: TY-SB01FB)
g Function Board by other manufacturers
[SLOT POWER ON]
Start the power supply that was stopped.
1) Press as to select [SLOT POWER ON].
2) Press the <ENTER> button.
f The power supply to the Function Board is started.
Note
f [SLOT POWER ON] cannot be operated when the following Function Board is installed.
g 12G-SDI Terminal Board (Model No.: TY-SB01QS)
g Function Board for 12G-SDI Optical (Model No.: TY-SB01FB)
g DIGITAL LINK Terminal Board (Model No.: TY-SB01DL)
g Wireless Presentation System Receiver Board (Model No.: TY-SB01WP)
[SLOT FORCED TERMINATION]
Forcefully stop the power supply.
1) Press as to select [SLOT FORCED TERMINATION].
2) Press the <ENTER> button.
f The confirmation screen is displayed.
3) Press qw to select [OK], and press the <ENTER> button.
f The power supply to the Function Board is stopped.
Note
f Use [SLOT FORCED TERMINATION] only when the operation of the Function Board needs to be shut down forcefully because it cannot be
shut down by normal operation of the Function Board.
f [SLOT FORCED TERMINATION] cannot be operated when the following Function Board is installed.
g 12G-SDI Terminal Board (Model No.: TY-SB01QS)
g Function Board for 12G-SDI Optical (Model No.: TY-SB01FB)
g DIGITAL LINK Terminal Board (Model No.: TY-SB01DL)
g Wireless Presentation System Receiver Board (Model No.: TY-SB01WP)
158 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
The power is supplied to the Function Board even when the projector is in standby mode.
The power supply to the Function Board is stopped when the projector goes into standby mode.