Table of Contents
Advertisement
[OPERATION SETTING]
Set the operation method of the projector.
The settings are reflected when "Initial setting (operation setting)" (x page 72) in the [INITIAL SETTING]
screen is already set.
If you change the settings while using the projector, the duration until the brightness decreases to half may
shorten or the brightness may decrease.
Setting [OPERATING MODE]
1)
Press as to select [OPERATION SETTING].
2)
Press the <ENTER> button.
f The [OPERATION SETTING] screen is displayed.
3)
Press as to select [OPERATING MODE].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
[ECO]
[QUIET]
[USER1]
[USER2]
[USER3]
*1 Estimated runtime is the time until the brightness decreases to approximately half of the time of delivery when the projector is used with the
[PICTURE] menu → [DYNAMIC CONTRAST] set to [3] and under environment of 0.15 mg/m
and is not the warranty period.
5)
Press as to select [APPLY].
6)
Press the <ENTER> button.
f The confirmation screen is displayed.
7)
Press qw to select [OK], and press the <ENTER> button.
Note
f If the consolidated runtime of the projector exceeds 20 000 hours, replacement of the components inside the projector may be required. The
consolidated runtime can be confirmed in the [STATUS] screen. Refer to the [PROJECTOR SETUP] menu → [STATUS] for details.
Setting [MAX LIGHT OUTPUT LEVEL]
Adjust the maximum level to correct screen brightness according to the changes in brightness of the light source.
1)
Press as to select [OPERATION SETTING].
2)
Press the <ENTER> button.
f The [OPERATION SETTING] screen is displayed.
3)
Press as to select [MAX LIGHT OUTPUT LEVEL].
4)
Press qw to adjust.
Operation
Press w.
Press q.
5)
Press as to select [APPLY].
6)
Press the <ENTER> button.
f The confirmation screen is displayed.
7)
Press qw to select [OK], and press the <ENTER> button.
Chapter 4 Settings — [PROJECTOR SETUP] menu
Set this item when high luminance is required. The estimated runtime is approximately 20 000
hours
.
*1
The brightness will decrease compared to [NORMAL], but set this item to prioritize the life of the light
source. The estimated runtime is approximately 24 000 hours
The brightness will decrease compared to [NORMAL], but set this item to prioritize the operation with
low noise. The estimated runtime is approximately 20 000 hours
Set [MAX LIGHT OUTPUT LEVEL] and [LIGHT OUTPUT] individually.
Increases the maximum level of brightness correction.
Decreases the maximum level of brightness correction.
dust. The value of runtime is just an estimate,
3
Adjustment
.
*1
.
*1
Range of adjustment
5.0 % - 100.0 %
ENGLISH - 159
Advertisement
Table of Contents
