Table of Contents
Advertisement
Installing the SFP module
The following is an example of installation procedure for the SFP module. Please also check the operating
instructions and setup guide of the SFP module.
1)
Remove the port cover.
f Pull out the port cover of the SFP port.
2)
Install the SFP module to the SFP port. (Fig. 1)
f With the circuit board of the SFP module visible from the bottom, securely insert the SFP module all the
way.
f Remove the protection cap on the <SDI OPT 1 IN> terminal, <SDI OPT 2 IN> terminal, or <SDI OPT OUT>
terminal, if there is any, before using.
Attention
f The removed port cover and the protection cap will be needed in following cases. Store them so that they can be attached in the future.
g When the SFP module not required anymore is removed
g When there is a terminal not to be used
g When storing the SFP module
Chapter 2 Getting Started — Installing the Function Board
SFP ports
SFP modules
Fig. 1
Circuit boards
ENGLISH - 57
Advertisement
Table of Contents
