Table of Contents
Advertisement
Setting the projector
1)
Connect the projector to a computer using a LAN cable.
2)
Turn on the power of the projector.
3)
Press the <MENU> button to open the [NETWORK] menu from the main menu.
f The [NETWORK] screen is displayed.
4)
Press as to select [WIRED LAN], and press the <ENTER> button.
f The [WIRED LAN] screen is displayed.
5)
Perform the [WIRED LAN] setting.
f Refer to [WIRED LAN] (x page 205) for details.
Note
f To connect to an existing network, perform after consulting your network administrator.
r Factory default setting
f Following setting has been made as a factory default.
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1] / [DNS2]
Operating the computer
1)
Turn on the power of the computer.
2)
Perform the network setting following the instruction of your network administrator.
f Operation from the computer is possible by configuring the network setting of the computer as follows if the
projector is in the factory default setting.
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
Connecting via wireless LAN
To use the wireless LAN function with the projector, it is necessary to attach the optional Wireless Module (Model
No.: AJ-WM50 Series) to the <USB> terminal.
Connecting example
Preparing and confirming the projector
1)
Insert the optional Wireless Module (Model No.: AJ-WM50 Series) all the way into the <USB> terminal.
Chapter 5 Operations — Network connection
OFF
192.168.0.8
255.255.255.0
192.168.0.1
None
192.168.0.10
255.255.255.0
192.168.0.1
IEEE802.11b/g/n
Optional Wireless Module
(Model No.: AJ-WM50 Series)
ENGLISH - 219
Advertisement
Table of Contents
