Advertisement
S T E P
2
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten until instructed.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tightened to fully go on.
NOTE: There are two options for weight installation.
2A. Attach Top Plate (#32) to Selector Rod (#30) using:
1 - (#4) M10x50mm Socket Head Cap Screw
1 - (#13) M10 Lock Washer
Option #1:
2B. Install Rubber Donuts (#33) and slide to the bottom of the Guide
Rods (F).
2C. Slide 20pcs of weight plates (#40) onto Guide Rods (F). Be careful
to hold guide rods steadily when installing weight plates.
2D. Install Top Plate (#32) onto the Guide Rods .
Note: Please make sure the grooves of the weight plates are faced
down during installation.
Option #2:
2B. Install Weight Risers (P) and slide to the bottom of the Guide Rods (F).
2C. Install Rubber Donuts (#33) and slide onto the top of the Risers (P).
2D. Install Top Plate (#32) onto the Guide Rods (F).
14
Advertisement
