Advertisement
S T E P
3
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of STEP 3E. Some components may be
pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench
tighten to fully go on.
3A. Attach Upright (C) to Front Base Frame (A) using:
2 - (#2) M10x75mm Hex Head Bolt
2 - (#7) M10x15mm Socket Head Cap Screw
6 - (#12) M10 Flat Washer
2 - (#13) M10 Lock Washer
2 - (#16) M10 Nylon Lock Nut
3B. Attach Seat Frame (D) to Upright (C) using:
2 - (#1) M10x100mm Hex Head Bolt
4 - (#12) M10 Flat Washer
2 - (#16) M10 Nylon Lock Nut
3C. Attach Seat Frame (D) to Front Base Frame (A) using:
2 - (#2) M10x75mm Hex Head Bolt
2 - (#7) M10x15mm Socket Head Cap Screw
6 - (#12) M10 Flat Washer
2 - (#13) M10 Lock Washer
2 - (#16) M10 Nylon Lock Nut
3D. Attach Top Frame (E) to Guide Rods (F) using:
2 - (#6) M10x20mm Hex Head Bolt
2 - (#12) M10 Flat Washer
3E. Attach Top Frame (E) to Upright (C) using:
2 - (#6) M10x20mm Hex Head Bolt
2 - (#12) M10 Flat Washer
16
Advertisement
