Advertisement
d
S T E P
4
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of STEP 4F. Some components may be
pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench
tighten to fully go on.
4A. Insert Knee Hold Down Frame (H) into Seat Frame (D)
4B. Fasten a M8x10mm Socket Head Cap Screw (37) into Knee Hold
Down Frame (H).
4C. Insert Foam Roller Bar (K) into Knee Hold Down Frame (H).
4D. Install Two Plastic Ring (31), two Foam Rollers (#30), and two
Plastic End Cap (#29) onto the Foam Roller Bar (K).
4E. Attach Seat Pad (#28) to Seat Frame (D) using:
2 - (#8) M8x6mm Hex Head Bolt
2 - (#8) M8 Flat Washer
4F. Attach Foot Plate (J) to Front Base Frame (A) using:
1 - (#25) Shaft
2 - (#9) M8x8mm Set Screw
18
Advertisement
