Emerson FloBoss 107 Instruction Manual page 40

FloBoss 107 Instruction Manual
2-10
Attachment posts
Figure 2-4. Adapter Plate (FB107 Expansion Rack)
To install the base unit and expansion rack to the FS1-ADP2 adapter
plate:
1. Place the unpowered FB107 base unit on the left side of the adapter
plate so that the attachment posts touch the right-most inside of the
plastic housing.
Slide the base unit to the right.
2.
You should feel the retaining clips attach to the back of the
Note:
base unit and the attachment posts should appear in the right-
most holes on the base unit's plastic housing.
3. Secure the base unit to the adapter plate by placing two plate screws
in the upper and lower right-most holes in the base unit. Torque
screws to 10-12 in/lbs.
Place the expansion rack on the right side of the adapter plate so that
4.
the attachment posts touch the left-most inside of the plastic
housing. The connector on the expansion rack should be adjacent to,
but not touching, the connector on the base unit.
5. Slide the expansion rack to the left until the connectors seat firmly
together.
You should feel the retaining clips attach to the back of the
Note:
expansion rack and the attachment posts should appear in the
left-most holes on the expansion rack's plastic housing.
6. Secure the expansion rack to the adapter plate by attaching two plate
screws in the upper and lower left-most holes in the expansion rack.
Torque screws to 10-12 in/lbs.
Installation and Use
Retaining clips
Issued Feb-07