Table of Contents
Advertisement
WARNING!
•
Do not get under the vehicle when it is on a jack. If
you need to get under a raised vehicle, take it to a
service center where it can be raised on a lift.
•
Only use the jack in the positions indicated and for
lifting this vehicle during a tire change.
•
If working on or near a roadway, be extremely care-
ful of motor traffic.
•
To assure that spare tires, flat or inflated, are
securely stowed, spares must be stowed with the
valve stem facing the ground.
Jack Warning Label
1. Remove the spare tire, jack and tools from the
stored location.
2. Loosen (but do not remove) the wheel lug nuts by
turning them to the left one turn while the wheel is
still on the ground.
3. Assemble the jack and jacking tools. Connect the
jack handle driver to the extension, then to the lug
wrench.
Assembled Jack And Tools
NOTE:
If your vehicle comes with factory equipped 35 inch
(88.9 centimeter) tires, a jack lift block is provided
in the rear cargo area. The jack lift block is used to
provide higher ground clearance when changing a
flat or spare tire. When placing the jack lift block
under the jack, be sure the bottom of the jack fits
securely inside of the raised edges of the block.
Jack Lift Box Usage
IN CASE OF EMERGENCY
4. Operate the jack from the front or the rear of the
vehicle. Place the jack under the axle tube, as
shown. Do not raise the vehicle until you are sure
the jack is fully engaged.
Front Lifting Point
NOTE:
Keep the jack and tools aligned while raising the
vehicle to prevent tool damage.
CAUTION!
Do not attempt to raise the vehicle by jacking on loca-
tions other than those indicated.
285
7
Advertisement
Table of Contents
