Wrangler Tops; Provided Tools; Lowering The Soft Top Into Sunrider® Position - Jeep WRANGLER 2023 Owner's Manual

Hide thumbs Also See for WRANGLER 2023:
Table of Contents

Advertisement

WRANGLER TOPS

PROVIDED TOOLS

For your convenience, a tool kit is provided with your
vehicle located in the center console. This kit includes
the necessary tools required for the operations
described in the following sections. All pieces fit into the
ratchet for easy use.
NOTE:
The soft top and the hard top are to be used indepen-
dently. Your vehicle warranty will not cover damage
resulting from both tops being installed at the same
time.
Provided Tools
1 — Ratchet
2 — #T50 Torx Head Driver
3 — #T40 Torx Head Driver
4 — 15 mm Socket
If your vehicle is equipped with a Dual Top (four door
models only), the soft top system will be provided in a
separate box located in the rear of the vehicle for ship-
ping purposes only.
LOWERING THE SOFT TOP INTO
SUNRIDER® POSITION
Use this QR code to access your digital
experience.
WARNING!
The fabric quarter windows and fabric top are
designed only for protection against the elements.
Do not rely on them to contain occupants within
the vehicle or to protect against injury during an
accident. Remember, always wear seat belts.
Make sure hands and fingers are clear of all pinch
points when installing and removing the soft tops.
The lift assist mechanism and side bows may
cause serious injury if fingers or hands get caught
in between.
GETTING TO KNOW YOUR VEHICLE
The soft top is not designed to carry any additional
loads such as roof racks, spare tires, building, hunt-
ing, or camping supplies, and/or luggage, etc. Also, it
was not designed as a structural member of the
vehicle and, thus, cannot properly carry any addi-
tional loads other than environmental (rain, snow,
etc.).
If the temperature is below 72°F (24°C) and/or the top
has been folded down for a period of time, the top will
appear to have shrunk when you raise it, making it diffi-
Scan me
cult to put up. This is caused by a natural contraction of
the vinyl or acrylic materials of the fabric top.
Place the vehicle in a warm area. Pull steadily on the
top fabric. The vinyl will stretch back to its original size
and the top can then be installed. If the temperature is
41°F (5°C) or below, do not attempt to put the top
down or roll the rear or side curtains.
Do not run a fabric top through an automatic car
wash. Window scratches and wax buildup may
result.
Do not lower the top when the temperature is
below 41°F (5°C). Damage to the top may result.
Do not move your vehicle until the top has been
either fully attached to the windshield frame, or
fully lowered.
Do not fully lower the top with the windows
installed. Window and top damage may occur.
65
CAUTION!
2
CAUTION!
(Continued)

Advertisement

Table of Contents
loading

Table of Contents