Table of Contents
Advertisement
96
GETTING TO KNOW YOUR VEHICLE
5. Using the provided #40 Torx head driver, remove the
four Torx screws located along the interior of the
windshield.
Step Five
1 — Outside Torx Screws
2 — Inside Torx Screws
NOTE:
Store all of the mounting bolts in their original
threaded holes and tighten for safekeeping.
6. Lower the windshield gently until it contacts the tie-
down bumpers (if equipped).
Step Six
1 — Washer Nozzle
2 — Bumper
3 — Tie-Down
7. Secure the windshield by passing a cinch strap
through the tie-down on either side of the hood and
on the windshield frame. Tighten the strap to secure
the windshield in place.
CAUTION!
Do Not Overtighten! Damage to the windshield could
result.
Adaptive Cruise Control (ACC)/Forward
Collision Warning (FCW) Sensor
Protective Cover — If Equipped
Your vehicle may be equipped with a protective cover
that is to be used whenever the windshield is folded
down in order to protect the Adaptive Cruise Control
(ACC)/Forward Collision Warning (FCW) sensor. To
install the cover, follow these instructions:
1. Secure the top part of the cover so that it hinges to
the header.
2. Swing the cover down and push on it so that it cov-
ers the opening.
3. Check to make sure the cover is secured properly.
NOTE:
Be sure to remove the cover before returning the wind-
shield to the normal position. Store the cover in the
cargo area.
Cleaning Instructions
During windshield down applications, dust/dirt can
accumulate in the cover and block the camera lens.
Use a microfiber cloth to clean the camera lens, mod-
ule, and inside cover, being careful not to damage or
scratch the module.
Advertisement
Table of Contents
