Table of Contents
Advertisement
330
SERVICING AND MAINTENANCE
Rear Base Tail Lamp Stop/Tail/Turn Bulb
Rear Base Tail Lamp Backup Bulb
Rear Base Tail Lamp Side Marker
Center High Mounted Stop Lamp (CHMSL)
License Lamp
NOTE:
Numbers refer to commercial bulb types that can be purchased from an authorized dealer. If a bulb needs to be replaced, visit an authorized dealer or refer to the applicable
Service Manual.
Bulb Replacement
NOTE:
Lens fogging can occur under certain atmospheric con-
ditions. This will usually clear as atmospheric condi-
tions change to allow the condensation to change back
into a vapor. Turning the lamps on will usually acceler-
ate the clearing process.
HALOGEN HEADLAMPS
See the following steps to replace:
1. Open hood and support using prop rod.
2. Remove the front grille. Turn the retainers along the
top a quarter turn counterclockwise and remove.
3. Pull the bottom of the grille away starting at one
side and working toward the other.
4. Remove the three screws holding the headlamp to
the vehicle.
5. Remove lamp from the vehicle.
Bulb Name
6. Remove the lamp from the collar.
7. Grab the bulb and rotate a quarter turn
counterclockwise.
8. Pull the bulb from the housing.
9. Push connector locking tab to the unlock position.
10. Remove connector from bulb.
11. Push connector onto new bulb base, and push the
connector locking tab to the lock position.
Do not touch the new bulb with your fingers. Oil con-
tamination will severely shorten bulb life. If the bulb
comes in contact with any oily surface, clean the bulb
with rubbing alcohol.
12. Reinstall bulb housing. Rotate the bulb a quarter
turn clockwise.
Exterior Bulbs
3157
7440
LED
LED
LED
CAUTION!
Bulb Number
FRONT PARK/TURN SIGNAL
See the following steps to replace:
1. Remove the front wheel liner fasteners to access
bulb sockets.
Wheel Liner
2. Turn the socket assembly a quarter turn counter-
clockwise and remove from housing. Pull the bulb
straight from the socket to replace.
Advertisement
Table of Contents
