Table of Contents
Advertisement
Place Tool Into Service Hole Of Plug To Remove
c. Using the tool, slowly pull upwards from the cen-
ter of the plug to remove.
8. Making sure the window on the upper half-door is
completely zipped closed, insert the upper half-door
into the lower half-door by placing the posts into the
post holes.
Lower The Upper Half-Door Into Post Holes
9. Push down firmly on the inside of the upper half-
door until it is fully seated in the lower half.
Push Down To Fully Seat Upper Half-Door
Door Latch Alignment
CAUTION!
Upon first installation of the half-doors, slowly set the
door almost to the closing position and check how
the door latch aligns with the body striker. Touch con-
dition between these components can result in dam-
age to both the door and the striker.
GETTING TO KNOW YOUR VEHICLE
Check Door Latch And Striker Alignment
NOTE:
Only adjust the door to fit correctly against the striker.
DO NOT adjust the striker, as this could affect the posi-
tioning of the full door.
If the door does not center align between the latch and
the striker, proceed as follows:
1. Loosen (do not remove) the four bolts on the door
hinges using the provided #T50 Torx head driver.
Hinge Bolt Locations
33
2
Advertisement
Table of Contents
